Spotting Scope Accessory Cage
The Spotting Scope Accessory Cage is designed for use with the Configurable Field Spotting Scope (CFS) 6-36x50mm F1. The cage provides the user with five M-LOK® mounting locations and ¼-20 threaded holes to attach the most popular accessories for competitive, recreational, and professional use.
Spotting Scope Accessory Cage
- Accessory Cage Body
- M-LOK® Mounting Slots (x5)
- ¼-20 Accessory Mounting Locations (x5)
- 7 Slot M-LOK® Picatinny Rail
- 5 Slot M-LOK® Picatinny Rail
- Cage Mounting Locations- 10-24 Thread (x6) 1-6: Tightening Sequence
Installation Instructions
To install the accessory cage, remove the lens cap from the eyepiece and slide the cage over the eyepiece with the horseshoe opening facing forward toward the objective. The accessory cage will slide on and fit between the body tube and the integrated base.
On the bottom, align the 6 holes of the cage with the corresponding holes on the integrated base and lightly secure a screw on either side to hold the cage in place. Continue to place screws in the other holes and tighten until they are flush with the base but not torqued to spec. Once all are in place, gradually tighten the screws to 35 in-lb using the tightening sequence shown to the left. If no torque driver is available, tighten 1/8 turn past initial resistance using the provided hex wrench.
NOTE: If the CFS 6-36 is purchased as a kit, the accessory cage will come installed from the factory. The M-LOK® picatinny rails can be installed by the user.
Reviews
There are no reviews yet.
Be the first to review “Spotting Scope Accessory Cage”